Electrical Quotes
from local electricians
Replace facia board holding Electrical Pole
Rob requested 3 quotes from Electricians in Chatswood
Scope:
Re-secure the electrical power pole that holds the electrical supply cable from the street.
Currently the electrical support post is bolted to the fascia board. The fascia board and its supporting rafter brackets are rotting and need to be replaced.
Will require Electrician with Level 2 license. i.e disconnect cable to street supply.
Details:
Disconnect the street electrical supply to property.
Remove fascia board. Note that the gutter has already been disconnected at the corners and will easily come off with the fascia board.
Cut out and replace three (x3) rotten rafter beams that the fascia is attached to.
Install supporting brackets for electrical pole in the same location as original pole.
Reconnect electrical metal pole to fascia, and bolt to new brackets.
Re-use the supply power cables into the building.
Close up the eve with cement fibre board (screw in).
Reconnect Electricity.
Work would ideally be done within a 1 x day so electricity can be restored.
Dimensions of Wood Work
Fascia Board Dimensions
Length: 5mtr (5000mm)
Height: 220mm
Width: 20mm
Rafter Beams Dimensions. 4x2inch
Quantity (QTY): x 3
Length: Approximately 500mm (50cm)
Height: 95mm (4inch)
Pictures can be emailed and can meet you at site to discuss.
Electricians that Responded
H4ORCE Electrical PTY LTD
Quote Details
- Suburb Chatswood, NSW 2067
- Specialisation Electrical Repairs
- Date Listed 13 Oct 2015 - 10:16 pm
Similar Quote Requests
Fix/replace a fire alarm and remove a light bulb that is stuck in a fitting
I have a smoke alarm thst is attatched to the electricity in the house and is...
Repair light fixtures (x3) and 1 power point
Light fixtures in living room and bedroom not working, power points need to...
Fit thermostat on Chef Classic Gas wall oven. Fix griller door.
Oven model GXC64IWNG.All settings on temperature dial give the same oven temp...
Vulcan oil heater requires servicing
I have a Vulcan oil heater about 30+ years old. It works fine except the...
Electrical Quotes
from local electricians
