Gareth requested 3 quotes from Electricians in Kew
SCOPE -
We need wiring to fans and sensors for a basement carpark in Kew.
See drawing attached. 1cm = 1m.
1. Receive 600 x 400 x 250d control board and install to location.
2. Connect in provided three phase sub-mains.
3. Wire 10amp, three phase carpark exhaust fan, less than 6m total length in fire rated conduit back to control board.
4. Wire 10amp, single phase carpark exhaust fan, less than 30m total length in fire rated conduit back to the control board.
5. Mount and wire 2 x supplied CO sensor back to the board in shielded, one pair cable. (Very low voltage), connect back to control board, less than 35m.
6. Commission and check that fans operate per requirement.
Works ready to start now.
G Star Electrics
Allpoints Electrical Contractors
brickhill electrical contractors
Electrical work.
Wiring for new kitchen and pantry:
power points
halogen lights and...
3 x Install lights
1 x install new fitting in place of existing
1 x install new light (with...
Replace existing smoke alarm
Replace existing Clipsal Lifesaver with a Clipsal 755PSMA2. Tradesman needs...
Electrical work
Replacing 8 baton lights
Installing 2 x ceiling fans (pre wired)
Installing...