Jobs Board Fencing & Gates Jobs in Jindalee Fencing & Gates Jobs in Jindalee

We have a common fence and a 20cm gap between our retainer wall. We need it fixed and puppy proofed We have a common fence and a 20cm gap between our retainer wall. We need it fixed and puppy proofed

would like to build a glass fence around the pool 3 X 7 mts would like to build a glass fence around the pool 3 X 7 mts

Front fence - approximately 6m long x 1.8m high, constructed from a combination of a rendered block and aluminium powder-coated picket top and bottom slats turned on their side. The rendered block... Front fence - approximately 6m long x 1.8m high, constructed from a combination of a rendered block and aluminium powder-coated picket top and bottom slats turned on their side. The rendered block section would be approximately 1.2m wide by 1.8m high. Adjoining this would be panels of aluminium powder-coated panels consisting of 38mm slats turned on their side, with the top rail and bottom rail being picket-style (i.e. rails are approximately 10mm from the top and bottom of the vertical slats). Job 2 - an entry gate measuring 1.8m high x approximately 1m wide, constructed from the same powder-coated aluminium slat panel (with slats turned on their side rather than facing front). This gate will be erected at the end of an existing covered entrance way so will be hung off an existing timber post and locked into another existing timber post. Level, easy access for fence and gate. Ready to start asap.

Job 1 - front fence 6m in length x 1.5m high, constructed from combination of brick, rendered pillars with aluminium black flat top in-fill panels. The two ends will not require brick pillars (one... Job 1 - front fence 6m in length x 1.5m high, constructed from combination of brick, rendered pillars with aluminium black flat top in-fill panels. The two ends will not require brick pillars (one end of aluminium panel will adjoin an existing timber post; other end can be a black aluminium post it cannot be seen from the front due to plants that are located in front of it. Job 1(b) - please provide a 2nd quote for a 1.8m hgh fence instead of a 1.5m high above. Job 2 - entry gate, approximately 1m wide x 1.8m high, constructed from black, flat-top style aluminium. Would prefer no cross-bar through the middle if possible, just a plain panel of flat-top.

BOth side fences need to be taken down and replaced. The property is located on a sloping block. There is currently no rear fencing we would like rear fencing. BOth side fences need to be taken down and replaced. The property is located on a sloping block. There is currently no rear fencing we would like rear fencing.