Repair gas space heater

Paul requested 2 quotes from Heating Professionals in Burwood

  I have a STADT P20 (in ceiling) gas space heater that has the following fault:

Flame ignition works main burners operate (but tell-tale LED on control board always remains off) .

As soon as the main burner is ON , the circulation fan starts (very little time delay, of the order of 3 seconds). With other heaters I know there is a time gap of several minutes before the circulation fan operates.

As soon as the fan starts the main burner goes to OFF .

Fan continues to operate for another minute or so and then shuts down.

The above process is automatically repeated around 3 times. And then everything stops.

To go through the above process again, the Unit requires a manual Reset.

It could be a flame detector fault, or perhaps too little time gap between main burner operating and circulation fan operating.

The service address is, Unit 2, No. 2 Renown Street, Burwood 3125

Please let me know approximately what the cost will be to repair.

Reply via e-mail (Also CC to my work e-mail) , or tel 03 98333038 ask for Paul

Heating Professionals that Responded

Rescue Plumbing

Quote Details

  • Suburb Burwood, VIC 3125
  • Specialisation Heating Repairs
  • Date Listed 26 May 2008 - 8:01 pm

Similar Quote Requests

DUCTED HEATING
DUCTED HEATING

Ducted heating system repair/upgrade
Dysfunctional remote control on an old Vulcan Electronic CX ducted heating...

Replace ducted heating and service and repair unit
Ducting needs replacing and unit needs servicing and new switch

Ducted heating service and repair.
Ducted heating service.